The harness is perfect! I already installed it on the Charger’s fresh 440 along with the engine harness as it sits on a K-frame stand awaiting installation. It will tap right into the A & B wiper harness and blower motor no problem. Guys like you are the unsung hero’s that reproduce all these harnesses for restoring Mopars. It kills all the extra time it would take to re-manufacture harnesses that are too far gone. Most of all, Your contribution to helping these old Mopars stay on the road is A1. My Charger R/T was a skeleton restoration. After being robbed of all it’s parts and parked out by a stock tank since 76′, you can only imagine what I was up against. All of the AC was gone, so hunting down all the OEM components was a challenge to say the least. Most of my time was focused on the AC than anything else and your harness was the “last” part I needed to complete the system. Researching and finding everything I needed that was worthy of re-commissioning, along with side jobs of the Charger’s restoration that were no brainers, it took me “Eight Months” to complete the OEM RV2 AC system. I just couldn’t help but write to tell you how happy and relieved I am. The Nightmare is finally over now…So now it’s time to move on the rest of the build. You may think…”It’s just a little harness”…..Not to me! It was a very long and important journey for this XS29 Charger R/T you helped me successfully finish….I felt like I was christening a ship installing your harness!

Can’t thank you enough….Sincerely, Brian